A clear sealer specifically formulated for use in conjunction with Fresco Breathable on exterior plasters and cement mortars. It stabilises the substrate, enhances adhesion and acts as a water barrier in the event of damage to the topcoats. Apply by brush, roller or low-pressure spray.

Coverage

10 – 12 m2 per litre, depending on substrate
Available in 1, 4 and 10 litres and test pots

For when you want to preserve the natural look and achieve good weather protection. For use as a sealer on both interior and exterior surfaces, this high MVTR (moisture vapour transmission rate) water-based sealer protects masonry or concrete surfaces (e.g. tilt-slab), giving a clear, colourless waterproof finish. Reduces dirt pick-up and mould.
Two coats are recommended, applied wet on wet by roller, brush or high-volume, low-pressure spray. Develops full weather protection properties after 3 – 4 weeks, or 2 – 3 cycles of wet weather.

Coverage

15 m 2 per litre
Available in 1, 4 and 10 litres and test pots

This scientifically developed base coat is recommended in the preparation of previously oil-painted surfaces, for gib-board, or surfaces in an unsound condition. Can be supplied tinted.

Coverage

12 – 16 m2 per litre
Available in 1, 4 and 10 litres and test pots

This clear acrylic sealer, available in flat, satin or gloss, can be applied over Fresco products to give even greater serviceability. Ideal for bathrooms, kitchens, playrooms and stairs. Easy clean – and still allows full colour.
Thin with 25% water. Apply by brush only. Two coats. describe_and_text

Coverage

20 m2 per litre
Available in 1, 4 and 10 litres and test pots

PLEASE CONTACT US AT FRESCO IF YOU HAVE ANY QUESTIONS ABOUT PREPARATION, COLOUR MATCHING OR APPLICATION.

FOR ANY TECHNICAL ADVICE PLEASE CONTACT US ON:

Tel: +64 09 415 8099
Fax: +64 09 415 8036
Email: info@fresco.net.nz
Website: www.fresco.net.nz
23 Schnapper Rock Road, Albany, Auckland